Safety Tips For HHO Dry Cell Hydrogen on demand systems

Installing Hydrogen on Demand on your auto or truck is not that difficult but you do need to follow some basic safety. Here are just a few safety tips to follow.

SAFETY RULES For Hydrogen on Demand
1. Everything in your hho injection system should be made from stainless steel, plastics, or alloys resistant to chemical erosion.
This is important because the catalyst (usually KOH) is corrosive.
2. A water reservoir, known as a bubbler, should be installed between the hydrogen (hho)-producing cell and engine along with a one-way valve in order to eliminate the possibility of an explosion going all the way to the cell. If you chose to use our hho dry cell kit, this is automatically taken care of as the reservoir is also the bubbler.
3. Your cell should have a pressure-release valve built in.
4. Your electrolysis system needs a fuse, a relay, and 12-volt ignition source so when the engine is not running the hho generator is off. This will also prevent damage to your motor and hho kit if it is run dry, it will over heat and blow the fuse, which shuts everything off.
5. The hho cell has the potential to produce lethal gases depending on the electrolyte, so be careful.
6. Never, under any circumstances, store HHO or oxyhydrogen gas, since it is much less stable than pure hydrogen and can explode.This is the
whole idea behind “Hydrogen on Demand”, Use the hho gas as you make it.

When You use our HHO Dry Cell kit for your Hydrogen on demand System these hho safety points are all covered.
Check out these complete Hydrogen on demand system using our HHO Dry Cell at hho2u.com

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s